Disclaimer: Don’t do anything stupid.
What I’m about to tell you is a trick that should NOT be used lightly.
However, in many cases Ophir sensors can be used for far higher powers than in the spec, as long as it’s only for a short time exposure.
If your application involves a laser which is not always on the target, such as the following setup, you might need a beam dump. Consider this: The deflectable mirror is used to direct the laser to its intended target
Going to Munich for LASER World of PHOTONICS 2015?
We’ll be showing several new products in Munich, not to mention quite a few of our classics.
You’re going to be busy. You can’t (and shouldn’t) go to every booth. So I’m going to very clear. Our booth is not for everyone. However,
With high power lasers, there’s always a safety concern for equipment and people nearby.
(Of course, I’m not qualified to give a detailed analysis of what needs to be taken into account for laser safety. For that, you should consult a laser safety officer.)
I want to specifically ask whether there’s an issue of laser light reflecting off power measuring equipment.
In applications where a human observer is involved (for example illumination applications), it is often important to measure using the eye-response-matched Photometric system of units. Ophir’s PD300-CIE is a photometric sensor, and is designed to measure illuminance (in units of Lux or Foot-Candles).