Using the USB Interface, you can connect several sensors to the PC by using one module for each sensor and if necessary, a USB hub. Ophir basic sensor to USB interface for single channel turn your PC or laptop into a full fledged Ophir multi-channel laser power/energy meter. Just install the software, plug the sensor into the interface module and the USB cable from the module to the PC USB port.
pgs. 98-107 (587 KB)
Starlab User Guide
Ophir Photonics laser power meters and PC interfaces works on the smart plug interface allowing any Ophir meter to work with most Ophir sensors. USBI is part of Ophir laser measurement instruments.
|PC Software & Drivers
||This section describes various ways to interface the USBI to your PC as well as the software options available.|
|StarLab||The StarLab application together with the USB interface turns your PC or laptop into a full-fledged Ophir laser power/energy meter. Supports all Ophir laser power/energy sensors. Up to 8 sensors can be displayed at once on one PC. By using the Ophir COM objects, you can control the StarLite, Juno, USBI, Nova II, Vega and Pulsar-1/2/4 devices from your own application.|
|LabView||Library supplied for a complete measurement interface with most of our USB speaking devices (StarLite, Juno, Nova-II, Pulsar, USBI, Vega). Makes use of our new COM object.|
|Firmware||Embedded Software for USB Interface
USBI firmware (version 1.45)
Use StarLab to upgrade the firmware of your device. Press Here for step-by-step instructions.