For maximum ease of use there is the continuously variable attenuator that can vary its attenuation over a very wide range just by pushing
and pulling the filters laterally. The attenuator consists of two opposite wedges of ND glass. The surfaces are arranged so that no parallel
surfaces face each other so as to eliminate interference effects.
The variable attenuator uses the same C mount thread as the other components so it can be combined with additional stackable filters and
beam splitters if necessary as shown.
Ordering Information
Item
Description
P/N
LBF-50 filter set
Compact screw in filter holder with set of ND filters. Attenuations from low to 106
SP90081
ND1 stackable filter (red housing)
4mm spacing screw on filter for camera with transmission of between 20% and 5% depending on spectral
range Can be stacked and combined with other filters and beam splitters.. One filter is included with Spiricon
cameras
SPZ08234
ND2 stackable filter
(black housing)
4mm spacing screw on filter for camera with transmission of between 7% and 0.5% depending on spectral
range. Can be stacked and combined with other filters and beam splitters. Two filters are included with
Spiricon cameras
SPZ08235
ND3 stackable filter
(green housing)
4mm spacing screw on filter for camera with transmission of between 2% and 0.05% depending on spectral
range. Can be stacked and combined with other filters and beam splitters
SPZ08253
Variable filter
Continuously variable filter for complete control over beam intensity. Especially useful for pulsed lasers. Varies
the intensity over more than 4 orders of magnitude between wavelengths 350nm and 1100nm. Can be stacked
and combined with other filters and beam splitters
SPZ17012
Filter holder and 50x50 filter
set
Filter holder with set of 4 standard Schott 50X50mm neutral density filters. Useful to reduce intensity before
inputting into 4X beam reducer. Mounts to standard ¼" thread, ½" diameter laboratory rod
SPZ08240
Filter for 355nm-V2; give an
undistorted image of the
355nm light.
Silicon cameras can see the 355nm 3rd harmonic radiation of YAG. The YAG however usually emits some light
at 532nm and 1064nm as well. This filter filters out the other 2 wavelengths to give undistorted image of the
355nm light
SPZ08246
Filter for 1300nm
For all cameras that can operate at 1300nm but are quite insensitive there. This filter filters out all light below
1200nm to allow viewing 1300nm radiation without background interference
SPZ08242
4mm spacer
Blank stackable spacer / filter holder where 4mm spacing is needed but no attenuation is needed
SPG01698
5mm spacer
Spacer ring for adapting 12.5mm recess CS cameras to 17.5mm recess C mount lenses
SPG02106
8mm spacer
Spacer ring for adapting 4.5mm recess cameras to work with 12.5mm recess CS mount lenses
English
日本語
中文
Deutsch
русский
Variable Neutraldichtefilter und Abschwächer 
Print
Version
